Balboa-water-group ML550 - Mach 3 Quick Reference Guide Manual de usuario descargar pdf

EL/GL Series - Mach 3

Heat

Cool Warm Jets 1 Jets 2 Blower Light Mode

ML550 Quick Reference Guide

Initial Start-up

When your spa is first actuated, it will go into Priming mode

(after displaying some configuration information). Please

see the M-7 Installation Instruction Manual for complete

instructions on Power-up and Pump Priming.

The Priming mode will last for up to 4 minutes and then the

spa will begin to heat and maintain the water temperature

in the Standard mode. You can exit Priming mode early by

pressing “Cool” or “Warm.”

Cool/Warm

Press the “Cool” or “Warm” button once to display the set

temperature. Each time either button is pressed again, the

set temperature will increase or decrease depending on

which button is pressed. After three seconds, the LCD will

automatically display the last measured spa temperature.

Jets 1

Press the “Jets 1” button once to turn pump 1 on or off,

and to shift between low and high speeds if equipped. If

left running, the pump will turn off after a timeout period.

The pump 1 low speed timeout on some systems may be

as long as 4 hours.

On non-circ systems, the low speed of pump 1 runs

when the blower or any other pump is on. It may also

activate for at least 1 minute every 30 minutes to detect

the spa temperature (polling) and then to heat to the set

temperature if needed, depending upon mode. When the

low speed turns on automatically, it cannot be deactivated

from the panel; however, the high speed may be started.

1 2

EL/GL Series - Mach 3HeatCool Warm Jets 1 Jets 2 Blower Light ModeML550 Quick Reference GuideInitial Start-upWhen your spa is first actuated, it w

YXcYfX$`ejkild\ekj%ZfdMode This button is used to switch between Standard, Economy, and Sleep modes. Press “Mode” to enter mode programming, press “C

Sin comentarios

Balboa-water-group ML550 - Mach 3 Quick Reference Guide Manual de usuario