Balboa-water-group ML900 - Mach 2.1 User Guide Manual de usuario

Jets 3 OptionJets 1 OptionInvertBlowerFiberJets 3 OptionTime Warm Jets 1 Jets 2 Jets 3 OptionCoolMode/Prog InvertBlowerFiber LightF2TLF1PLML900 User G

Page 8Periodic Reminder Messages (Press the “Mode” button to reset a displayed reminder.*)Message ** Frequency *** Action RequiredEvery 7 days Test an

Page 9Jets 4 (optional on some systems)Press the “Jets 4” button once to turn pump 4 on or off, and to shift between low and high speeds if it is a

P/N 40348-99_B 01/26/2006Warning! Shock Hazard! No User Serviceable Parts.Do not attempt service of this control system. Contact your dealer or serv

EL/GL SERIES (Mach 2.1) CONTROL WITH ML900 PANELThe ML900 panel can be used with the EL8000, EL5000, EL2000 and EL1000 systems. This user guide lists

Temp Set (80°F - 104°F / 26.0°C - 40.0°C)The last measured temperature is constantly displayed on the LCD.Note that the last measured spa temperature

Jets 2 (optional on some systems)Press the “Jets 2” button once to turn pump 2 on or off, and to shift between low and high speeds if it is a two-spee

Light Some systems are equipped with both a spa light and a fiber optic light; however, only one can be accessed by this panel. (Larger panels may be

Page 5Ozone (optional)On most systems, the ozone generator (if installed) runs during filter cycles (except when pump 1 is operating at high speed on

Diagnostic MessagesMessage MeaningNo message on display.Power has been cut off to the spa.“Overheat” - The spa has shut down.1 On some systems, an ala

Diagnostic Messages (continued)Message MeaningWhen your spa is first actuated, it will go into Priming mode.orTemperature unknown.Temperature not curre