Balboa-water-group Plug N' Click Heater On An Older Spa System Manual de usuario descargar pdf

Remove Heater Straps & Install Plug N’ Click Heater

– Turn off power to the system.

– Using a Phillips screwdriver unscrew the

2 screws on top of the enclosure and open the cover.

– Locate the 2 sensors holder on the circuit board.

– Remove the 2 heater sensors by depressing the

clip and gently pulling on the wire to remove

each sensor cable.

– Use a 3/8” (9.5mm) nut drive to remove the

2 nuts on the circuit board holding the heater

copper straps to the system.

– Remove the 2 heater nuts with a 3/8” (9.5mm)

wrench.

– Remove heater from system.

PARTS AND TOOLS YOU NEED

– 3/8” (9.5mm) torque wrench

– 3/8” (9.5mm) open end wrench

– 3/8” (9.5mm) nut driver

– Flat-head and Phillips screwdriver

– Heater Adapter Cable (25696)

– Replacement Balboa Heater

– Nyogel 760G (36308) and a stick

– Loctite Glue

STEP 1 OPEN THE SYSTEM BOX

STEP 3 REMOVE THE 2 HEATER SENSORS

STEP 2 REMOVE NUTS ON CIRCUIT BOARD

STEP 4 REMOVE NUTS ON HEATER

WARNING!

Please contact an electrician or your local electrical company when

connecting any spa electrical components. DO NOT OPEN THE SPA

SYSTEM AND ATTEMPT TO CONNECT THE CABLE CONNECTORS

YOURSELF. The high electrical voltage will harm or kill you.

Balboa Heater

Nyogel 760G and a stick (36308)

Heater adapter cable (25696)

Loctite Glue

1 2

Remove Heater Straps & Install Plug N’ Click Heater– Turn off power to the system.– Using a Phillips screwdriver unscrew the 2 screws on top of

Sin comentarios

Balboa-water-group Plug N' Click Heater On An Older Spa System Manual de usuario